Forcepoint V5000 Quick Start Manual

Quick Start Guide
Forcepoint V5000
Web or Email Protection Appliance

Before you begin...

Plan your deployment before setting up the appliance. See the
back of this guide for a deployment overview and reference sheet.
1 Verify Contents
Power Cable
Ethernet Cables (4)
Bezel (faceplate)
Contact Forcepoint Technical Support if any items are missing.

Rack Installation

2
To rack the V5000 appliance, use a rack tray (not included).
1. Obtain a rack tray and install into desired server rack.
2. Place appliance on tray
and secure to server rack
using mounting screws on
front of appliance.
©2016 Forcepoint LLC. All rights reserved.
3 Determine Security Mode
The appliance supports the following security modes:
• Web (Web Filter & Security or TRITON AP-WEB)
• Email (TRITON AP-EMAIL)
Based on your subscription and deployment plan, determine the appropriate security mode for this
appliance.
4 Connect Network Cables
Connect the appliance interfaces required by the security mode for this appliance. Cat 5E cables (or
better) are required. Do not use crossover network cables.
*Not used for Web Filter & Security.
Serial Cable
5 Connect Input Device & Power On
Serial Port Connection
Connect a computer to serial port using null
modem cable (provided). Or, connect a terminal
server to serial port using a straight-through
cable (not provided). Serial port settings are:
9600 baud, 8 bits, no parity.
OR
Keyboard/Monitor Connection
Connect a monitor and keyboard to appliance,
either directly or through a KVM (keyboard/
video/mouse) switch.
Power On Appliance
6
Power on the appliance and check the following indicators:
Front
• Power button is illuminated.
Rear
• LEDs for connected interfaces (NICs) are green.
• System status indicator (LED left of power supplies) is solid
blue.
Contact Forcepoint Technical Support if any indicators are not
illuminated correctly.
7

Configuration Overview

Please refer to the TRITON Appliances Getting Started guide for
more details.
Initial Configuration
Firstboot Script
• Configure security mode.
• Configure Appliance Controller interface (C).
• Configure NTP servers/system time.
Appliance Command Line
• Configure applicable network interfaces.
• Configure other settings as desired.
Web Mode
TRITON Manager
• Enter subscription key, update Master Database, configure
Network Agent, and configure policies in TRITON Manager.
• Requires Windows Server 2008 R2 or Windows Server
2012 or 2012 R2.
Content Gateway Manager (proxy)
• If your site uses the Forcepoint proxy, configure user
authentication and select protocols.
Email Mode
TRITON Manager
• Complete configuration wizard, enter subscription key, and
configure policies in the Email module. Configure email DLP
policies in the Data module.
• Requires Windows Server 2008 R2 or Windows Server
2012 or 2012 R2.
QSG210-100_RevH