Philips dynalite DTS900 Installation Manual

.........
DTS900 & DTS900M
Temperature Sensor
Installation Manual
features

Wide measurement range - 0º to 50ºC, accuracy +/- 1ºC

Available with or without user adjustable knob

Status LED - Indicates Heating, Cooling, Idle modes

Many Adjustable Parameters - Including top and bottom set
points, hysteresis, on and off timers

1 x RS485 DyNet Port - Available on a 5 way screw terminal
strip

Powerful Internal PLC - Custom scripts can be written to
provide process control based on conditional logic and
protocol translation between Dynalite's DyNet and other
protocols

Powered from the DyNet Network – No need for an
external power supply
dimensions
DTS900
important notes
Read Instructions – We recommend that you read this
Instruction Manual prior to commencement of installation.
Special Programming – This device will only operate in basic
modes unless programmed via a computer. If programming is
required, contact your local agent for details.
Installation Location – Install on a vertical surface in a dry
location, at chest height.
RS485 Data Cable – Use screened, stranded RS485 data cable
with three twisted pairs. Segregate from mains cables by 300mm
minimum. Connect devices in a 'daisy chain'. A data cable that is
connected to an energised device is live. Do not cut or terminate
live data cables.
DTS900M