Related Manuals for Husqvarna 70 PP
Summary of Contents for Husqvarna 70 PP
- Page 1 MODEL MODEL MODEL 70 PP MODEL 70 PP 70 PP 70 PP OWNER’S MANUAL OWNER’S MANUAL OWNER’S MANUAL OWNER’S MANUAL...
- Page 2 Remove the spreader and components from carton and place hopper up-side down on a padded surface as shown. Insert ends of leg into handle brace as shown and align holes. Attach brace and leg to frame using (4) 1/4-20 x 2 1/4”...
-
Page 3: Operation
(setting A, B, or C). See “PATTERN ADJUSTMENT” for details. Always fill the spreader on the driveway or sidewalk-not on the lawn. Make sure screen is in hopper and spreader is in the “OFF” position Start spreader moving before opening port. - Page 4 SETTINGS AND SPREAD WIDTH SETTINGS AND SPREAD WIDTH SETTINGS AND SPREAD WIDTH Two major factors should be considered when determining correct spreader settings of any product: 1. The product application rate, or the amount of material applied per 1,000 square feet.
-
Page 5: Application Rate
— — — 15 — — — — 5 — — — — 3.5 J 4.5 70 PP settings for those units listed. 6 6.5 7 11 12 13 — M — — — — 20 — — — —... -
Page 6: Maintenance
The conversions should be used as guidelines for establishing proper rate settings for the particular product being applied. Steps for obtaining the most accurate settings are outlined in the “How to Determine Spreader Settings and Spread Width” section of this manual. -
Page 7: Calibration Instructions
CALIBRATION INSTRUCTIONS CALIBRATION INSTRUCTIONS CALIBRATION INSTRUCTIONS CALIBRATION INSTRUCTIONS The spreader was factory calibrated, however, calibration should be checked occasionally to assure optimum performance. Pull the on/off lever to the “OFF” position. Set the rate control plate to setting “B”. Pointer Screw... - Page 8 Parts List Model 70 PP Parts List Model 70 PP Parts List Model 70 PP Parts List Model 70 PP PART OF OUR SERVICE IS PROVIDING REPLACEMENT PARTS. Parts may be obtained through your local distributor. Be sure to give:...