Related Manuals for Husqvarna 70 LP
Summary of Contents for Husqvarna 70 LP
- Page 1 OWNER’S MANUAL OWNER’S MANUAL OWNER’S MANUAL OWNER’S MANUAL MODEL MODEL MODEL MODEL 70 LP 70 LP 70 LP 70 LP...
- Page 2 Remove components from carton and place spreader upside down on a padded surface. Install LH. & RH. handle braces to frame as shown using four (4) 1/4-20 x 2 1/4” hex bolts and nuts but do not tighten. 3/16 Dia x 2” Cotter Pin Drive Wheel Turn spreader upright.
- Page 3 Handle Grip ON/OFF Control Secure On/Off cable to the clamp bracket using the cable clamp and #10-24 x 5/8” screw and locknut as shown but do not tighten. Place On/ Off control in the “ON” position and set the rate retting dial to the “WASH”...
-
Page 4: Operation
Check the product package for the rate setting, and recommended swath width. Turn the spreader off by pulling the lever to the “OFF” position as shown. The rate setting is adjusted by rotating the rate cam to the desired setting. The rate cam locks at each setting. -
Page 5: Application Rate
HOW TO DETERMINE SPREADER HOW TO DETERMINE SPREADER HOW TO DETERMINE SPREADER HOW TO DETERMINE SPREADER SETTINGS AND SPREAD WIDTH SETTINGS AND SPREAD WIDTH SETTINGS AND SPREAD WIDTH SETTINGS AND SPREAD WIDTH Two major factors should be considered when determining correct spreader settings of any product: 1. - Page 6 70 LPsettings for those units listed. N1/2 P1/2 — — — — — — 70 LP settings when only the product weight, square BAG RATE Pounds of fertilizer used per 1,000 sq. ft. of coverage — — — — —...
-
Page 7: Maintenance
MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE 1. Never store unused material in spreader. Return unused product to its original container. 2. Open and wash spreader thoroughly after each use and dry completely in sun or heated area. 3. Oil the axle bearings, impeller shaft bearing in hopper. - Page 8 Parts List Model 70 LP Parts List Model Parts List Model Parts List Model PART OF OUR SERVICE IS PROVIDING REPLACEMENT PARTS. Parts may be obtained through your local distributor. be sure to give: 1. SPREADER MODEL NUMBER 2. SPREADER NAME 3.