Panasonic WJ-HD500 Instructions Manual

Extension units
Hide thumbs Also See for WJ-HD500:

Advertisement

Quick Links

Before attempting to connect or operate this product,
please read these instructions carefully and save this manual for future use.
WARNING:
• To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
• All work related to the installation of this product should be made by qualified service personnel or system installers.
CAUTION:
• Read the label on the bottom of the unit for identification of this product, and the power ratings.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is interned to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient magni-
tude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and mainte-
nance (servicing) instructions in the litera-
ture accompanying the appliance.
The serial number of this product may be found on the rear
of the unit.
You should note the serial number of this unit in the space
provided and retain this book as a permanent record of your
purchase to aid identification in the event of theft.
Model No.
Serial No.
WJ-HDE500
WJ-HDE505
Model No.
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CARE-
FULLY.
This appliance is supplied with a moulded three pin mains plug for your
safety and convenience.
A 5 amp fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the replacement
fuse has a rating of 5 amp and that it is approved by ASTA or BSI to
BS1362.
H
Check for the ASTA mark
or the BSI mark
fuse.
If the plug contains a removable fuse cover you must ensure that it is
refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement
cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic
Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCK-
ET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE
REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE
CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET.
If a new plug is to be fitted please observe the wiring code as shown
below.
If in any doubt please consult a qualified electrician.
WARNING: This apparatus must be earthed.
IMPORTANT
The wires in this mains lead are coloured in accordance with the follow-
ing code.
Green-and-yellow:
Blue:
Brown:
As the colours of the wire in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows.
The wire which is coloured green-and-yellow must be connected to
the terminal in the plug which is marked with the letter E or by the earth
I
symbol
or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal in
the plug which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
in the plug which is marked with the letter L or coloured red.
How to replace the fuse
Open the fuse compartment with
a screwdriver and replace the fuse
and fuse cover.
Extension Units
For U.K.
G
on the body of the
Earth
Neutral
Live
FUSE

Advertisement

Table of Contents
loading

Summary of Contents for Panasonic WJ-HD500

  • Page 1 NO USER-SERVICEABLE PARTS INSIDE. cover is obtained. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. A replacement fuse cover can be purchased from your local Panasonic Dealer. IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCK- ET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE The lightning flash with arrowhead symbol, REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.
  • Page 2 General The WJ-HDE500 and WJ-HDE505 are the Extension Units for installation with the digital disk recorder WJ-HD500 to extend its disk capacity. Extension is available by connecting a maximum of 6 extension units in the SCSI chain while an extension unit can contain up to four HDDs.
  • Page 3: Front View

    Turn on this switch (peripherals) first, then the power of the WJ-HD500. r SCSI In connector [EXT IN] Confirm all HDD access lamps go out before turning Connect the WJ-HD500 or other Extension Unit with off this switch. Switch off the power of the WJ- a SCSI cable.
  • Page 4 Mounting HDDs A maximum of 4 HDD units (locally procured) can be mounted on one extension unit. This page describes how to install #1 HDD. Repeat the same procedures as #1 for #2 through #4 HDD. HDD Positions Inside The Lid The HDD units should be installed into the proper open- ings in order as shown.
  • Page 5 Set the unit address with jumper connector on the HDD as shown. HDD #2 & #4 (SLAVE) Note: For further details, refer to the instructions included in the HDD unit. Jumper Position HDD #1 & #3 (MASTER) Jumper Position Place the HDD into the appropriate opening, then fix it with 2 screws.
  • Page 6: Scsi Connection

    Use a WJ-HDE500 if the 3rd position is the end of the SCSI chain. Error Connection Connect each error output with CONTROL port on the WJ-HDD500 rear panel as shown. The WJ-HD500 will display a warn- ing of the thermal error on the monitor.
  • Page 7: Switch Settings

    Switch Settings Set the MODE switch #2 on the rear of the WJ-HD500 1234 to ON when connecting with the extension unit. MODE Set the SCSI ID for each unit by pressing the [–] and [+] buttons on the rear of the extension unit.
  • Page 8: Troubleshooting

    Troubleshooting Phenomenon Cause What to do Securely plug the cord into AC outlet and AC No power is supplied. Power cord connection is insufficient. inlet.. HDD access lamps blink. The Inner connector is loosening. Securely plug the inner connector. Ventilation openings or fan is blocked. Remove obstacles.

This manual is also suitable for:

Wj-hd505Wj-hde500Wj-hde505

Table of Contents