Advertisement
Quick Links
INSTALLATIONINSTRUCTIONS
_J_,_;i_
%_ _ _
_ _i_ _D
_
Gatherthe requiredtools and parts beforeste_ng installation.
Read and Iollowthe instructions providedwith any tools listed
here.
Tools Needed
•
Flat-bladeand Phillips
•
Tape measure
screwdrivers
•
Drmll and _a="orsmaller bit
•
Level
Through-the,Wall
Installation:
In addition to the tools listed above, the Iollowing tools are
needed Ior through-the-wall
installation.
•
,Saw
•
1" (2,5 cm) orthicker
lumber
•
Wood preservative
•
Caulk
•
#10 x 1"wood screws(7)
Parts Supplied (on some models)
Check thatall parts are includedin parts package.
C
O
E F
A. Foam window sash seal
B. t&qndowlock brecke(s (2)
C. #10x
(_'pan-head
Ph#/tps
screws (6)
O. 110 x _" pan-head
Philflps screws (3)
E. #lO x _/4"round-head screws (6)
F, llOx
tla" pan-head Phil#ps
SCreWS(3)
G. Top channel
H. SMe curtains (2)
I. Foam seal
IMPORTANT:Observe all governingcodes and ordinances.
Check the locationwhere air condiUoner w ill be installed.Proper
installation is your responsibility. Make sure you ha_eeverything
necessaryfor correct installation.
The locationshouldprovide:
•
Groundedelec_'ical outle(within 4 It(122 cm) ol where the
powercord exitsthe air conditioner.
NOTE: Do not usean extensioncord,
•
Free movementof air in room to be cooled.
•
A largeenoughopeningforthe airconditionen
•
Adequatewall supportforweightof air conditioner. A ir
conditionerweighsbetween99 and 95 Ibs (36to 44kg).
NOTE: Cabinet louversmustnot be obstructed.Air mustbe able
pass Ireelythrough the cabinetlouvers,
A. Cabinet louvers
NOTE: Installation parts are suppliedfor double-hungwindows
up to 40" (101.6 cm)wide. A special Wide WindowKitis available
Imm your dealeror servicecenter.See "Accessories."
P/N 66129901291
1
Advertisement
Related Manuals for Frigidaire FAR105S1A11
Summary of Contents for Frigidaire FAR105S1A11
- Page 1 INSTALLATIONINSTRUCTIONS _J_,_;i_ %_ _ _ _ _i_ _D Gatherthe requiredtools and parts beforeste_ng installation. IMPORTANT:Observe all governingcodes and ordinances. Read and Iollowthe instructions providedwith any tools listed Check the locationwhere air condiUoner w ill be installed.Proper here. installation is your responsibility. Make sure you ha_eeverything necessaryfor correct installation.
- Page 2 A. 27" (68.6cm) minimum B. 16114"(41.3 cm)minimum • Height: 16" (40,6 cm) plus twice thickness of wood used to build frame. • Depth: 21tz"(6,4 cm) minimum to 6"(15,2cm) maximum, A. _6"(4o.ecm) C. Wood thickness B. 22sis" (57. 5 cm) D. 2 h" (6.4) minimum to 6 "(15.2cm) maximum.
-
Page 3: Installation Instructions
INSTALLATION INSTRUCTIONS 4. Removethe window lock bracketand screwfrom the air E]messlve Weight Hazard condil_oner a nd set aside,(onsome models) Uee two or more poople to move end Install air conditioner, Failure to do so can rneult In beck or othor Injury. Remove packaging materials •... - Page 4 NOTES: Bottom view • Handle the air conditionergently, • Be sure your air conditioner cabinet does notfall outof the opening during installation or removal. The place where the power cord exits the air conditioner should be no more than 4 ft(122 cm) from a grounded 3 prong outlet •...
- Page 5 Install Cabin_ _to Wi_d_ Attach Side Curtains to Window Frame 1. Pull the left-handcurtainout untilitfits intothe window • Handlethe air conditioner gently. channel.Use a s/=z" d rillbitto drilla starter holethrough the • Be sure yourair conditionercabinetdoes not{all outof the hole in the curtain housingand intothe lowerwindow sash. openingduring installation or removal.
- Page 6 Co_ta Installation 1. Insert seal behind the top of the lower window sash and againstthe glass of the upperwindow. 2. Place one window-lock bracket on Lop of lower window and against upper window sash on each side of the window. 3.
- Page 7 • Use 1" (2.5 cm) or thickerlumberIor wood Irame. Insertcabinet into the Iremed wall opening.The top of the cabinetshuuld extend zf4 (19.1 ram) into the room.If there is trim,the cabinet should extend _/4 (19.1 mm) past the trim. A. Outside width 8.
- Page 8 ! Electrical Shock Hazard ! Connect green ground wire to ground screw, 5. Insertfronttabs of frontpanel intotop of cabinetand swing frontinto place, Failure to do so can result In death or electrical shock. 6. Attach bottomIront of panelwith frontpanelscrews,Replace controlknobs{onsome models), 3.