Buffalo ELFSAFE Manual

ELFSAFE / ELFSFB MANUAL
S
__ __ __ __ __ __ __ __
(record your personal 3-8 digit security code) (Electronic Floor Safe Serial Number)
COMPLETE & SUBMIT REGISTRATION CARD TO VERIFY OWNERSHIP
KEEP THIS MANUAL AND SALES RECEIPT FOR FUTURE REFERENCE
If you experience a problem or have questions, visit call Customer Service at 1-636-532-9888,
Monday-Friday, 8 AM - 4 PM Central Time. A copy of the sales receipt is required.
#1) Insert Key and rotate left, while rotating knob right. Open door.
#2) Remove battery cover and install (4) AA batteries (1.5V) batteries. Replace battery cover.
(NOTE: Batteries are included.)
#3) Before closing door, be certain your keys are not inside the safe. Now close door.
Factory default code is set to 1 5 9 B . To open using electronic lock, press 1 5 9 B .
(These numbers are preset. You should change the entry code as soon as possible after opening the
safe to insure proper security.)
After you have entered the factory code, you will need to turn the knob clockwise to open the door.
You will have 5 seconds to turn the handle before the locking mechanism is reactivated. When the valid
code entered, the lock will beep once and the green LED turns on. When an invalid code is entered, the
lock will keep beeping and the yellow LED flashes.
ENTERING YOUR SECURITY CODE
CHANGING USER CODE #1
ALWAYS PERFORM THE OPERATION WITH THE DOOR OPEN
1) Press the "reset" button, the lock will beep once and the yellow LED turns on.
(The "reset" button is located on the back cover or the side frame (hinge side).
2) Enter your new digit code (3-8 digits), then press "A" or "B" button.
3) Test the lock operation several times before closing the door.
DO NOT SHUT THE DOOR UNTIL YOU HAVE CONFIRMED THAT THE NEW
SECURITY CODE HAS BEEN ENTERED CORRECTLY.
*WRONG TRY PENALTY --- Entry of three (3) consecutive invalid codes starts a
20 second lock out. (It will continue to beep for 20 seconds and the key pad will
not respond to any operation.)
If the code fails, follow steps 1 and 2 again. If the code works successfully, record your combination
number on the front of this form or somewhere in your records, then you should lock the safe. When you
open the safe in the future, enter the security code you have set followed by the "A" or "B" button".