Sealey TRM5.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
‰
DO NOT use tools if damaged.
8
DO NOT use this tool for purposes other than for which it is designed.
8
Maintain tools in good and clean condition for best and safest performance.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
9
Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
9
Keep children and unauthorised persons away from the work area.
9
DO NOT use the thread repair set when you are tired or under the influence of alcohol, drugs or intoxicating medicine.
8
Account for all tools and parts being used, DO NOT leave them in or near an engine. Return all parts to the case and store this in a
9
safe, dry, childproof location.
WARNING! Failure to comply with these instructions may result in damage to the thread repair set or work piece and/or personal injury.
‰
WARNING! The warnings referred to in this guide cannot cover all possible conditions and situations that may occur. It must be
‰
understood that common sense and caution are factors which cannot be built into this product, but must be applied by the operator.
2. INTRODUCTION
Creates a stronger internal thread in soft metals. Ideal for repairing damaged or stripped internal threads. Protects tapped threads against wear
and damage. Set includes drill bit, thread tap, insert installation and lug breaking tool. Supplied with three different lengths of thread insert.
3. SPECIFICATION
Model No: Replacement inserts
TRM5.V2 TRM5R
TRM6.V2 TRM6R
TRM8.V2 TRM8R
TRM9.V2 TRM9R
TRM10.V2 TRM10R
TRM12.V2 TRM12R
TRM14.V2 TRM14R
4. INSTRUCTIONS
4.1 Drill out the damaged thread using the correctly sized twist drill
bit provided.
© Jack Sealey Limited
THREAD REPAIR MASTER KITS
TRM5.V2, 6.V2, 8.V2, 9.V2, 10.V2, 12.V2,
MODEL NO'S:
14.V2
Thread lengths
3.5, 5, 7mm (5 of each)
4, 6, 9 (5 of each)
6, 9, 12mm (5 of each)
7, 14mm (3 of each), 11mm (x4)
7.5, 15mm (3 of each), 11mm (x4)
9, 18mm (2 of each), 14mm (x4)
10, 21mm (1 of each), 16mm (x3)
4.2 Tap drilled hole using screw tap provided.
Original Language Version
Thread size
M5 x 0.8mm
M6 x 1mm
M8 x 1.25mm
M9 x 1.25mm
M10 x 1.5mm
M12 x 1.75mm
M14 x 1.25mm
TRM.V2 kits Issue:1 28/03/22