Lakeland Mills CF1123 Quick Start Manual

Please check contents before assembly. If any items are missing or damaged, do not take the unit back to
the store. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems
directly for you.
PORCH SWING COMPONENTS
Preassembled Swing Back
Preassembled Swing Seat
2 Arm Supports
2 Arms 24" Long
NOTE: Cracks or Checks in logs are part of the natural beauty of
cedar logs and should not be considered defects.
Rubber Block of Wood
Mallet & hammer
or
NOTE:
Read all instructions before starting.

To start lag screws, hammer into wood about 1/2"

then use wrench to tighten.
Do not completely tighten any screws until the unit

is fully assembled and setting on a level surface.
Use a rubber mallet (or a block of wood between

the hammer and the unit) to drive doweled ends
into holes as far as possible.
Install seat end onto seat. Align holes in seat end with
STEP 1
dowels on seat as shown in picture right. Repeat on
other side. Secure with screws perpendicular to dowel.
IMPORTANT: The single hole should be placed toward
the front for the seat. (See figure right).
CF1123 & CF1124 CEDAR LOG PORCH SWING
2 - 21"
12" Long Seat Ends
TOOLS REQUIRED
7/16
Socket
7/16"
or
Pencil
Tape Measure
or Marker
2 - Swing
Bars - 45"
Long
(Not included or needed when A-Frame is purchased)
S Hooks
packaged
separately
for porch
swing
only
# 2
Phillips
Screwdriver
Regular
Screwdriver
Please Note: After you have installed the seat ends onto the
seat secure with (4) 2" screws.
PORCH SWING HARDWARE
(Shown smaller than actual size)
Two S Hooks
Ten Screws
Two 3/8"Washers
Two 3/8" x 5"
Eye Bolts
Four 1/4" x 5"
Lag Screws
Two Barrel
Nuts
Four 1/4" Washers