Sealey PBJS Series Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear safety
instructions footwear
1. SAFETY
‰
WARNING! ALWAYS USE LOAD RATED STANDS TO SUPPORT
LIFTED LOADS
9
Read, study and understand all warnings and operating instructions prior
to use. The usershall work in accordance with this manual.
▲
DANGER! Use the jack for lifting and lowering only.
▲
DANGER! DO NOT place any part of the body beneath the lifted load
unless the load is fully supported by rated axle stands.
▲
DANGER! DO NOT place any part of the body beneath the load during lifting or lowering.
8
DO NOT exceed the rated capacity of the jack, load or maximum stroke.
8
DO NOT adjust the overload valve, modify or use the jack for any purpose other than for which it is designed (lifting and lowering
mechanical devices).
8
DO NOT leave elevated loads unattended, unless safe from others in a garage or workshop.
8
DO NOT modify the jack.
9
The operator must watch the jack and the load during all movements.
9
Ensure the jacking area is solid and level. Increase the jacking area with a solid flat plate (steel) if jacking on tarmacadam or grass.
9
Keep others away from the work area.
9
Lift only on areas of the vehicle specified by the vehicle manufacturer. Refer to manufacturer's instructions on proper lifting.
9
Centre load on saddle prior to lifting.
9
Some vehicles require an adapter to properly engage the frame for lifting.
9
Use only attachments, restraints or adaptors supplied by the manufacturer.
8
DO NOT move or dolly the the vehicle whilst on the jack.
9
Ensure the jacking area is clutter free and that there is adequate lighting.
‰
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations
that may occur. It must be understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be applied by the operator.
‰
WARNING! Failure to heed these warnings may result in personal injury and/or property damage.
2. INTRODUCTION
Fitted with overload valve. Base and reservoir machine welded for increased strength and eliminates leakage. Supplied with 2-piece handle.
3. SPECIFICATION
Model No. PBJ3S
Hydraulic Lift 115mm
Max. Height 360mm
Min. Height 185mm
Screw Extension 60mm
Capacity 3tonne
© Jack Sealey Limited
BOTTLE JACKS
MODEL NO'S: PBJ2S
Beware crushing Wear eye
hands protection
PBJ5S PBJ8S PBJ10S
125mm 145mm 150mm
402mm 447mm 460mm
207mm 222mm 231mm
70mm 80mm 80mm
5tonne 8tonne 10tonne
Original Language Version
Wear protective
gloves
PBJ12S PBJ15S PBJ20S
150mm 150mm 150mm
441mm 441mm 453mm
231mm 231mm 243mm
60mm 60mm 60mm
12tonne 15tonne 20tonne
PBJ30S PBJ50S
165mm 160mm
440mm 425mm
275mm 265mm
N/A N/A
30tonne 50tonne
PBJS series Issue 1 24/05/22