Advertisement
Quick Links
π
H-4694, H-4695
RIPACK HEAT GUN
EXTENSION
1.
In order to use a Ripack Heat Gun Extension, you
must first switch to the stronger, red-tipped igniter
provided to you. To do so, press down on the black
switch to release the trigger (See Figure 1).
Figure 1
2. Pull the trigger forward to expose black igniter
(See Figure 2).
Figure 2
PAGE 1 OF 2
1-800-295-5510
uline.com
ATTACH EXTENSION
3. Remove black igniter from chamber and replace
with red-tipped igniter. Make sure the red tip is
facing out (See Figure 3).
4. Close the trigger.
5. Now that the igniter has been changed, you can
add the extension on the end of the gun. Start by
removing the chrome combustion nozzle with a twist
and pull motion.
6. Attach extension at the end of the gun with a twist
and push motion.
7.
Remove plastic protective cap from the end of the
extension and replace with the chrome combustion
nozzle. Your gun is ready for use.
Figure 3
0515 IH-4694
Advertisement
Summary of Contents for U-Line RIPACK H-4694
- Page 1 π H-4694, H-4695 1-800-295-5510 uline.com RIPACK HEAT GUN EXTENSION ATTACH EXTENSION In order to use a Ripack Heat Gun Extension, you 3. Remove black igniter from chamber and replace must first switch to the stronger, red-tipped igniter with red-tipped igniter. Make sure the red tip is provided to you.
- Page 2 OPERATION Depress trigger half way to allow chamber to fill 2. After allowed time, fully press down on the trigger to with gas. When using the H-4694 4' Ripack Heat ignite heat gun. (See Figure 5) Gun Extension, hold for two seconds. When using the H-4695 7' Ripack Heat Gun Extension, hold for five seconds (See Figure 4).