Philips MICRO UNDERWATER Installation Instructions

100 Craftway, P.O. Box 128
Littlestown, Pennsylvania 17340-0128
Phone: 800-331-4185
10' UNDERWATER CABLE
[CABLE SOUS-MARIN DE 10 PI]
[VIS DE FIXATION DU COUVERCLE]
FIXTURE HOUSING
[BOITIER DU LUMINAIRE]
FACTORY SEALED
LIQUID-TIGHT CONDUIT FITTING
[CONNECTEUR ETANCHE]
This fixture is intended for installation in accordance with the National Electrical Code and local code
specifications. Failure to adhere to these codes and instructions may result in serious injury and/or damage
to the ballast and void the warranty. These instructions do not purport to cover all details or variations in
equipment, nor to provide for every possible contingency related to installation, operation, maintenance,
or mounting situation. Should specific problems occur that are not addressed by these instructions, contact
your Sales Representative or distributor for assistance. Retain these instructions for future reference.
SAFETY WARNING:
ALWAYS TURN FIXTURE OFF/DISCONNECT POWER AND ALLOW TO COOL BEFORE
PERFORMING ANY MAINTENANCE, INCLUDING RELAMPING AND CLEANING!
This fixture can become very HOT! The fixture housing and lens, especially if it is glass, can become hot enough
to blister hands. Attention should be paid to where the fixture is mounted, particularly if it can be touched by
children or pets. To help prevent premature failure, decreased performance, overheating and risk of fire, keep
fixture and lens clean and free of leaves, mulch, debris and mineral deposits from water. The fixture and lens
can be cleaned using a soft cloth and a solution of mild liquid soap and warm water. Wipe clean and dry with a
soft, lint-free dry cloth. Avoid polishing fixture or lens.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS!
WARNING - Lamp gets HOT quickly! To reduce the risk of FIRE OR INJURY TO PERSONS:
Do not operate fixture with a missing or damaged lens/lens assembly.
Contact only switch or plug when turning fixture on or off. Do NOT touch hot lens or housing.
Turn off or unplug fixture and allow to cool before relamping. Keep lamp away from combustibles.
Do NOT touch lamp with bare hands at any time, use a soft cloth as oil from skin may damage lamp.
32000781, revision F
Fax: 717-359-9672
COVER LOCKING SCREW
INSTALLATION INSTRUCTIONS:
MICRO UNDERWATER
CLEAR POLYCARBONATE LENS GUARD
[PROTECTEUR DE LENTILLE EN
POLYCARBONATE TRANSPARENT]
TWIST-LOCK FIXTURE COVER
[COUVERT "TWIST-LOCK"]
SILICONE GASKET
[JOINT EN SILICONE]
50W MAX., 12V
MR16 LAMP (NOT
INCLUDED)[NON COMPRIS]
BI-PIN TYPE SOCKET
[DOUILLE A DEUX BROCHES]
CONCRETE BASE (WITH
ADJUSTABLE LOCKING
SWIVEL ARM) [BASE EN
BETON (AVEC BRAS
PIVOTANT REGLABLE)]
®
LISTED
page 1 of 2