GE JP626 Dimensions And Installation Information

JP626WK/CK/BK
GE 36" Built-In Electric Cooktop
®
Dimensions and Installation Information (in inches)
Note: Check local codes for required breaker size
KW Rating
Important: Maintain 5" (12.7 cm) minimum
240V 7.4
vertical clearance between the cooktop bottom
208V 5.6
and any combustible surfaces.
Clearance not required when installing wall
Breaker Size
oven underneath. Requires an 18" minimum
240V
40 Amps
†
from cooktop to adjacent overhead cabinets.
Units are furnished with a 48" flexible
208V
30 Amps
†
armored cable.
JP626 is approved for use over GE 30" Single Wall Ovens only. Refer to
cooktop and wall oven installation instructions packed with product for
current dimensional data.
If installed with a GE Telescopic Downdraft System, consult both
cooktop and downdraft installation instructions packed with product
before installing. Cooktop gas/electric supply may need to be re-routed
to install downdraft.
The countertop must be at least 26" deep with a flat surface area of
23-1/2" or more, front to back. In addition, other clearances to the front
edge of the countertop must be considered.
This cooktop cannot be installed in countertops that cannot accept
screws, such as granite or marble, etc.
Installation Information: Before installing, consult installation instructions
packed with product for current dimensional data.
For answers to your Monogram, GE Profile
®
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center
®
800.626.2000.
or
™
service,
21
35-1/2"
Cooktop
3
19-1/8"
33-7/8"
2-1/2"
(min.)
clearance to
side wall
from cut-out
Electrical junction box 16" MIN.
below countertop
13" MAX.
depth
30" MIN. to
unprotected
18" MIN.
cabinet
clearance to
to cabinet
2-1/2" to
rear wall
from cut-out
3-3/4"
5" (12.7 cm) Min.
Vertical Clearance
Specification Revised 4/06
3-3/4"
side wall
Cut should
not interfere
with cabinet
structure
at front
Listed by
Underwriters
Laboratories
321350