The Buffalo TurboUSB utility can greatly improve the data transfer rates to and from your Buffalo USB hard drive. Other USB devices are not affected by TurboUSB software. Installation To install TurboUSB on your computer, insert your DriveNavigator CD in your computer’s CD drive.
Page 3
Using TurboUSB To use TurboUSB, you must first enable it. From the Start menu, choose Programs > BUFFALO > TurboUSB > TurboUSB for HD-HSU2. Click Enable and follow the directions to start TurboUSB.
Page 4
When the wizard instructs you to disconnect and then reconnect the USB cable, click on the ‘Safely Remove Hardware’ icon release the device before unplugging it. You may also turn TurboUSB off from the same window by clicking Disable and following the steps. You will have to unplug and reconnect the USB hard drive to complete disabling TurboUSB.
Page 5
Uninstalling To remove the Buffalo TurboUSB utility from your computer, click Start > Programs > BUFFALO > TurboUSB > Uninstaller. This will launch an uninstall screen. Click on Start to run the uninstallation.