GE Tetra Contour Manual

GE
Lighting
Tetra Contour
®
LED ARCHITECTURAL SERIES
Product Codes
75521, 75526, 75529, 75541 & 62186
Preparation
This product is intended solely for the use of non-residential architecture lighting and is not intended for use in any other applications.
1
Remove the protective film from the light guide.
3
Cut the light guide to the required length using a
hacksaw, chop saw (cross cut or veneer blade only), band
saw, or other appropriate plastic cutting tool.
imagination at work
Forming Instructions
2
Mark the light guide at the required length, adding 0.5 in.
(13mm) for every 16 in. (406mm) to account for shrinkage
during the forming process.
4
Fill the entire light guide channel with the GEXNBA
Silicone Bend-Aid(s) and press into place. Bend-Aid must
be installed prior to heating and forming.
NOTE: The GEXNBA Silicone Bend-Aid is reusable.
CAUTION: DO NOT heat and form the light guide with
the light engine installed.
Light Guide
Silicone Bend-Aid