Talkaphone ETP-MT Installation Instructions

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D'INSTALLATION
PERTINENT, PAR UNE PERSONNE QUI CONNAÎT BIEN LES PRODUIT ET
SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS
I. Introduction
This manual is for the Blue Light Emergency Phone Tower (model ETP-MT), Radius Emergency Phone
Tower (model ETP-MT/R) and the ECO TOWER® Emergency Phone Tower (model ETP-MTE) installation
only. For instructions on installing the anchor bolts into the foundation, see the TOWER ANCHOR BOLT
INSTALLATION INSTRUCTIONS or ETP-PDMK INSTRUCTIONS for Parking Deck Mounting Kits.
II. Contents
Before beginning installation, make sure you have all the included components. Each TOWER PARTS kit
includes:
Qty. Part Number
3 42941
2 42843
1 68590
1
ETP-EL or
ETP-EL12/24
III. Installation
It is the installer's obligation to ensure compliance with all national, regional,
and local regulations.
1. After removing the tower from its shipping carton, install the LED Blue Light on top of the tower, feeding
the power cord and control wires through the top of the tower. If installing an ETP-MT/R tower series,
you will need to remove the cap plate atop the tower first. Fasten the LED Blue Light to the tower with
three (3) 10-24 pan head tamperproof screws. Replace the cap plate at the top, if used. It is not
necessary to connect power lines at this point.
2. Slide the LED Panel Light over the studs with the LEDs facing down. Tighten down using the two (2) 6-
32 hex nuts (provided). Be careful not to over tighten to avoid cracking the LED Panel Light.
Install one 3/4"-10 hex nut and one washer (found in the MT/R BOLT KIT or MT BOLT KITon each
3.
anchor bolt 2.5-3.5" above grade to top of washer. This will allow for a 1/2" air gap between the
foundation and the tower, which will allow airflow and prevent moisture problems. Verify that the nuts
are level (0° pitch).
Page 1 of 4
Copyright 2017 Talkaphone • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talkaphone All rights reserved.
TOWER PARTS KIT Installation Instructions
Description
10-24 x 3/4" Pin-In-Torx Pan head(TS-20 driver required)
6-32 hex nut
LED Panel Light (12-24V AC/DC - 120VAC)
120VAC LED Blue Light or
12/24V AC/DC LED Blue Light
– See Figure 1 –
ETP-MT | ETP-MTE | ETP-MT/R
Rev. 1/27/2017