Advertisement
Quick Links
DynaMO Quick Install Card
1
Unpacking Your DynaMO kits:
1 MCM3xxxAP/SS or 1 MCJ3xxxAP/SS Drive
1 frame kit with brackets, bezel and retaining clip
(PLEASE USE ONLY THE 8 METRIC SIZED SCREWS, THIN TREAD, INCLUDED)
1 Magneto-Optical Media; capacity depends on drive model.
1 IDE cable or 1 SCSI cable
1 Power cable
1 DynaMO CD-ROM with installation software and drivers
1 each Limited Warranty Guide, Summary Card and Registration Card
2 "Get MO For Less" Labels
2
Getting Started:
1. Turn off computer.
IMPORTANT: Be sure to unplug your computer from the power source before removing the cover.
Failure to do so could result in an electrical shock hazard to you.
2. Remove the system cover or casing.
3. Discharge static electricity. Touch one of the connectors on the back of your computer and ground
yourself on a metal object to discharge any static electricity from your body.
IMPORTANT: If you do not discharge static electricity from your body before touching the disk drive,
damage to the drive could result.
Advertisement
Summary of Contents for Fujitsu DynaMO MCM3 AP Series
- Page 1 DynaMO Quick Install Card Unpacking Your DynaMO kits: 1 MCM3xxxAP/SS or 1 MCJ3xxxAP/SS Drive 1 frame kit with brackets, bezel and retaining clip (PLEASE USE ONLY THE 8 METRIC SIZED SCREWS, THIN TREAD, INCLUDED) 1 Magneto-Optical Media; capacity depends on drive model. 1 IDE cable or 1 SCSI cable 1 Power cable 1 DynaMO CD-ROM with installation software and drivers...
- Page 2 Configure Jumper Settings For IDE Drives (MCM3xxxAP and MCJ3xxxAP): 1. Jumper settings at factory shipping CNH5 CNH5 : Short 5-6 short-circuited: Sets the master device. 3. Setting slave device mode 2. Setting master device mode CNH5 CNH5 Slave device setting. Shows the setting for recognizing Master device setting.