Page 2
XTAG-2 Quick Start Guide (9.9) 1 Introduction The XTAG-2 debug adapter is a simple adapter card based on an XS1-L1 64TQFP event-driven processor device. It can be used to connect XMOS development boards with an XSYS2 connector to PCs, providing a JTAG interface to the board and a 5V power supply from a USB 2.0 port.
Run the Windows Installer to install the tools. Follow the instructions on screen. 2. Connect your development board to your system Connect the 20-way IDC header on the XTAG-2 connector to the left XSYS connector on the development board. Plug the XTAG-2 into a USB 2.0 connector on your development system.
The following steps explain how to get started with the XTAG-2. 1. Connect the XK-1 card to your system Connect the 20-way IDC header on the XTAG-2 to the left XSYS connector on the XK-1 card. Plug the XTAG-2 into a USB 2.0 connector on your development system.
The following steps explain how to get started with the XTAG-2. 1. Connect the XK-1 card to your system Connect the 20-way IDC header on the XTAG-2 debug adapter to the left XSYS connector on the XK-1 card. Plug the XTAG-2 into a USB 2.0 connector on your development system.
Page 6
“Information”) and is providing it to you “AS IS” with no warranty of any kind, express or implied and shall have no liability in relation to its use. XMOS Ltd. makes no representation that the Information, or any particular implementation thereof, is or will be free from any claims of infringement and again, shall have no liability in relation to any such claims.