Page 1
INSTALL DECKING IN HALF THE TIME INSTALLATION GUIDE & WARRANTY INFORMATION FOR ANY ANGLED INSTALL Note: Before beginning installation, please visit camofasteners.com/installation for best practices. REV. 8/19/19...
Page 2
Fastening the first board and last board: Secure the first board along the house or at the outside of the deck. By face fastening with the appropriate screw for the deck material at each joist. 1. On the outside edge 2. Place EDGECLIP™ at At the same time, slide the of your installed starter...
Page 3
FOR USE WITH ANY ANGLED DECKING PATTERN Fastening the first board and last board: Secure the first board along the house or at the outside of the deck. By face fastening with the appropriate screw for the deck material at each joist. 1.
Page 4
Simply remove the snap-off legs off EDGECLIP™ or the distance to allow for expansion wings off EDGEXCLIP™ so that and contraction at this joint. the clips can sit side-by-side on the double joists.
Page 5
REMOVING AND REPLACING A DECK BOARD - FOR EITHER CLIP 1. EDGECLIP™ and EDGEXCLIP™ 2. Pull up on the board and it make removing or replacing a will come easily out of position. board easy. Start by backing all of the screws out of the joist that are holding the board.
This Limited Warranty does not apply where damage to the deck board product is attributable, in whole or in part, to improper installation of either the deck board product itself or the CAMO® Clips, EdgeClip™ and EdgeXClip™. This is your sole and exclusive remedy for any product defect. NNC assumes no...
Page 7
FOLLOW US ON SOCIAL MEDIA! @CAMOFASTENERS @CAMODECKFASTENERS CAMOFASTENERS.COM/VIDEOS SIGN UP FOR OUR NEWSLETTER: CAMOFASTENERS.COM/NEWSLETTER OR CONTACT US AT: INFO@CAMOFASTENERS.COM NATIONALNAIL.COM...