Tripp Lite Medical Grade IS Series Owner's Manual

IS Medical Grade
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
CAUTION!
DO not connect to an ungrounded outlet. DO not use with extension cords or adapters that eliminate the connection to ground. The
isolation transformer is designed for indoor use only. Install the isolation transformer away from heat emitting appliances such as
radiators or heat registers. Do not install where excessive moisture or other conductive contaminants are present. Do not use with life
support appliances if a malfunction or failure could cause failure or significantly alter the performance of the life-support device. Do
not use this equipment within oxygen-enriched atmospheres or within 0.3 m at a point from which an oxygen-enriched atmosphere is
intentionally ventilated.
Installation
1. Connect Your Isolation Transformer to
Your AC Power Line
Plug the power cord into a standard, 3-wire
grounded, 120V AC, 60 Hz utility outlet.
Note: The isolation transformer only meets UL60601-1
when plugged into a hospital-grade outlet.
2. Connect Equipment to Your Isolation
Transformer
Plug the AC power cords of your equipment into
your isolation transformer. Do not use extension
cords or adapters that eliminate the connection
to ground. Connect equipment that requires a
external connection to ground to the isolation
transformer's potential equalization conductor,
labeled " " on the unit.
3. Turn Your Isolation Transformer On
Flip the switch to provide clean AC power to the
isolation transformer's receptacles. "O" is the
ON position,"I" the OFF. Do not overload your
isolation transformer. Excess load on the isolation
transformer will cause its circuit breaker to trip;
if it does, the outlets will cease to provide power.
Reduce the load on the isolation transformer
down to your unit's Output Power rating by
unplugging excess equipment, then depress the
circuit breaker rocker to reset the breaker and
restore power.
Output floating, neutral output
conductor not grounded.
Register your product for quicker service and ultimate peace of mind.
You could also win an ISOBAR6ULTRA surge protector—a $100 value!
Owner's Manual
Maintenance
Your isolation transformer requires no routine
maintenance. There are no user-serviceable parts
inside your isolation transformer; do not open it for
any reason.
Specifications
IS250HG
IS500HG
IS1000HG
IS1800HG
Medical/Hospital Grade
Protection
Your isolation transformer is UL 60601-1 listed,
classified as Class 1,Type B, Continuous Operation,
Ordinary Equipment. The isolation transformer
is Faraday-shielded and reduces the cumulative
leakage currents of all connected equipment below
100 microamps. As a further safety measure, your
isolation transformer is equipped with a hospital
grade plug and receptacles to reduce the risk of
accidental equipment disconnection.
PROTECT YOUR INVESTMENT!
www.tripplite.com/warranty
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2016 Tripp Lite. All rights reserved.
Isolation Transformers
™
Output Power
(Watts) Outlets
250W 2 NEMA 5-15RHG
500W 4 NEMA 5-15RHG
1000W 4 NEMA 5-15RHG
1800W 6 NEMA 5-15/20RHG
(UL 60601-1 Listed)
2-Year Limited Warranty
Seller warrants this product, if used in accordance with all applicable
instructions, to be free from original defects in material and workmanship
for a period of 2 years from the date of initial purchase. If the product
should prove defective in material or workmanship within that period, Seller
will repair or replace the product, in its sole discretion. To obtain service
under this warranty you must obtain a Returned Material Authorization
(RMA) number from Tripp Lite or an authorized Tripp Lite service center.
Products must be returned to Tripp Lite or an authorized Tripp Lite service
center with transportation charges prepaid and must be accompanied by a
brief description of the problem encountered and proof of date and place
of purchase.
This warranty applies only to the original purchaser who must have properly
registered the product within 10 days of purchase.
THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE
RESULTING FROM ACCIDENT, MISUSE, ABUSE OR NEGLECT. SELLER
MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY
EXPRESSLY SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY
APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES
OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE
WARRANTY PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY
EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES.
WARNING :The individual user should take care to determine prior to use
whether this device is suitable,adequate or safe for the use intended. Since
individual applications are subject to great variation, the manufacturer
makes no representation or warranty as to the suitability or fitness of these
devices for any specific application.
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification,
your Tripp Lite product has been assigned a unique series number. The
series number can be found on the product nameplate label, along with all
required approval markings and information. When requesting compliance
information for this product, always refer to the series number. The series
number should not be confused with the marking name or model number
of the product.
Product Registration
Visit www.tripplite.com/warranty today to register your new Tripp Lite
product. You'll be automatically entered into a drawing for a chance to win
a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply.
See website for details.
Tripp Lite has a policy of continuous improvement. Specifications are
subject to change without notice.