PRODUCT DESCRIPTION The LTC 8782/XX-01 is a Bosch to Vicon code translator designed to permit control of Vicon VPS system receivers from Bosch Allegiant controllers. It receives Bosch biphase code and transmits the appropriate commands in Vicon RS-422 format. There are four independent Vicon outputs.
The switches can be changed with power ON and the new settings will take affect immediately. SW1-6 SW1-1, SW1-2, SW1-3, & SW1-4 VICON BAUD RATE ADDRESS GROUP SELECTION 9600 Baud BOSCH VICON OFF: 4800 Baud 1~256 1~256 257~512 1~256...
Vicon code) code) Because of the different nature of Bosch and Vicon code structure, the indicators will show differ- ent patterns. The Rx indicator will flicker while Bosch biphase code is being received. (If the polarity is reversed, it should not light.) The Tx indicator will flash only when the Vicon output command changes.
Bosch pan, tilt, zoom, focus, and iris commands are converted to the appropriate Vicon com- mands. Bosch pre-position commands "Set" & "Shot" 1 thru 99 are converted to Vicon "Progam" & "Run" commands. Since Bosch aux commands are repeating, high pre-position commands are used for Vicon toggling commands according to the following table.