Hampton Research HR8-170 User Manual

18mm x 1.0mm
Circle Cover Slide Gizmo
User Guide
Compatibility
The 18 mm x 1.0 mm Circle Cover Slide Gizmo is compatible with:
• 18 mm diameter, siliconized circle glass cover slides (1.0 mm thick)
Recommended Circle Glass Cover Slides
HR3-515 - 18 mm x 1.0 mm Siliconized circle cover slides
- 1.0 oz pack (~ 45 slides)
HR3-517 - 18 mm x 1.0 mm Siliconized circle cover slides
- 10.0 oz case (~ 450 slides)
Description
The Dispenser holds up to 1 pack of 18 mm x 1.0 mm siliconized circle
cover slides. The dispenser is fitted with a metal
ment when loading and unloading cover slides. The Dispenser moves to the
right and left ends of the cover slide Gizmo along two chromed
rails are positioned over the cover slide
the 18 mm x 1.0 mm Circle Cover Slide Gizmo with 2 mm allen head screws.
A top edge of the Platform is notched at each cover slide position to allow
finger or forceps access to the cover slides dispensed onto the Platform. The
Base has four rubber feet to keep the 18 mm x 1.0 mm Circle Cover Slide
Gizmo flat and stationary. A black metal
with the 18 mm x 1.0 mm Circle Cover Slide Gizmo fits over the Dispenser to
keep cover slides clean during operation. See Figure 2.
Figure 1
Top View of the 18 mm x 1.0 mm
Circle Cover Slide Gizmo
Dispenser
Metal Knob
Using the 18 mm x 1.0 mm Circle Cover Slide Gizmo
1. Insert the metal Tab into the bottom slot of the
See Figure 2.
2. Position the chamber flat onto the table. Open the chamber door and
carefully insert the 18 mm x 1.0 mm siliconized circle cover slides. Figure 3.
Knob to allow easy move-
Platform . Each Rail is secured to
Cover Slide Chamber
Base
Chrome Rail
Cover Slide Chamber
Figure 2
Cover Slide Chamber
Tab
Figure 3
Rails . The
Opened Chamber
Door
3. Position the 18 mm x 1.0 mm Circle Cover Slide Gizmo such that the metal
supplied
knob on the dispenser is facing you. Clean any dust or debris from the 18 mm
x 1.0 mm Circle Cover Slide Gizmo. Position the Dispenser all the way to the
left end of the 18 mm x 1.0 mm Circle Cover Slide Gizmo. (Figure 1). Be sure
no cover slides are positioned on the Platform to the right of the Dispenser.
4. Align and insert the slide chamber into the slide dispenser. Remove the
2 mm Allen
metal tab.
Screw
5. There are two ways one can dispense the slides on the gizmo.
the knob attached to the Dispenser and slide the Dispenser all the way to the
right. Or, Place your thumb and first finger gently onto the front and back
top edge of the Dispenser, no need to press down on the Dispenser. Slide the
Dispenser all the way to the right end of the Platform until the Dispenser
is against the right end stop. Six cover slides will be positioned onto the
platform. See Figure 4.
Notched
Platform
Figure 4
.
Solutions for Crystal Growth
HR8-170
Insert Tab here
Tab inserted into
Chamber
Gently grab