GE JX9152 Installation Instructions Manual
GE JX9152 Installation Instructions Manual

GE JX9152 Installation Instructions Manual

Built-in trim kits
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

Installation
Instructions
Questions? Call 1-800-561-3344 or Visit our Website at: GEAppliances.ca

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT
— Save these instructions
for local inspector's use.
IMPORTANT
— Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions for future
reference.
• Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
• Completion time – 1 to 3 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• This kit is for use on models:PEB9159DJ, PEB9159SJ,
PEB9159EJ, CEB1599SJ.and CEB1599EL.
• This kit and microwave are approved for installation
alone or above any single electric wall oven. Do not
mount adjacent (within 2 feet) to any range, cooktop,
gas oven, or other microwave.
• This product is to be installed 3 feet above floor level.
• Do not alter or modify any part of this kit or the oven.
• For easier installation and personal safety, we
recommend that two people install this microwave
oven.
• Unplug the microwave oven before attempting
installation of this kit.
WARNING
— This oven must be plugged into a
properly grounded 3-hole, 120 volt receptacle as required
by the National Electrical Code.
WARNING
— Before beginning the installation,
switch power off at service panel and lock the service
disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
Microwave Oven
Built-In Trim Kits
JX9152 and JX9153

PARTS INCLUDED

PART
NOTE: This kit has extra screws to prevent the
technician from spending extra time locating a
replacement in case they lose one during installation.
1
QUANITY
Rear Duct
1
Bottom Duct
1
Trim Kit
1
Frame
Rail
2
16 required
Short Screws
3 extra
Long Wood
Screws
4 required
2 extra
29-6277
08-18 M

Advertisement

Table of Contents
loading

Summary of Contents for GE JX9152

  • Page 1: Before You Begin

    Installation Microwave Oven Built-In Trim Kits Instructions JX9152 and JX9153 Questions? Call 1-800-561-3344 or Visit our Website at: GEAppliances.ca BEFORE YOU BEGIN PARTS INCLUDED Read these instructions completely and carefully. IMPORTANT • — Save these instructions PART QUANITY for local inspector’s use.
  • Page 2: Installation Instructions

    Installation Instructions TOOLS YOU WILL NEED GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of an electrical short circuit, grounding reduces ■ 2 Phillips Screwdrivers (#1 & #2) the risk of electric shock by providing an escape wire for the electric current. This appliance ■...
  • Page 3: Install The Rails

    Installation Instructions 3 INSTALL THE REAR DUCT 1 LOCATE AND INSTALL THE BASE 1. Gently return microwave oven to its upright position. 2. Remove screw A. Set Base Pan into the front cabinet microwave oven cutout and center it right and left. Push back until the front flange is against the cabinet front wall.
  • Page 4 Installation Instructions 3 INSTALL THE REAR DUCT 6 SECURE THE RAILS TO THE (continued) CABINET 6. Use 3 short screws to secure back of rear duct to the Ensure the Base Pan and Bottom Bracket front flanges back of microwave oven, as shown. are tight against the cabinet, and that the screws holes are aligned.
  • Page 5: Avant De Commencer

    Instructions Trousse pour encastrer un four à micro-ondes d'installation JX9152 et JX9153 Des questions? Appelez le 1-800-561-3344 ou visitez notre site Web au : GEAppliances.ca AVANT DE COMMENCER PIÈCES INCLUSES ■ Lisez attentivement toutes ces instructions. IMPORTANT • — Conservez ces instructions PIÈCES...
  • Page 6: Instructions D'installation

    Instructions d'installation OUTILS NÉCESSAIRES INSTRUCTIONS DE MISE À LA TERRE Cet appareil doit être mis à la terre. En cas d'un court- ■ circuit électrique, la mise à la terre réduit le risque de 2 tournevis Phillips (no 1 et no 2) décharge électrique en fournissant un fil permettant au courant électrique de s'échapper.
  • Page 7 Instructions d'installation 3 INSTALLEZ LE CONDUIT ARRIÈRE 1 TROUVEZ ET INSTALLEZ LE PLATEAU DE LA BASE 1. Avec soin, remettez le four à micro-ondes à l'endroit. Mettez le plateau de la base dans l'ouverture pour 2. Enlevez la vis A. le four à...
  • Page 8 Instructions d'installation 4 INSTALLEZ LE FOUR À MICRO-ONDES 6 SÉCURISEZ LES RAILS AU CABINET Branchez le cordon d'alimentation dans la prise murale. Glissez doucement l'ensemble du four à micro-ondes dans l'armoire en faisant Assurez que les rebords avant de la base et du support du bas sont attention de ne pas coincer le cordon d'alimentation.

This manual is also suitable for:

Jx9153

Table of Contents