Advertisement
Quick Links
100 Craftway Dr.
Littlestown, Pennsylvania 17340-0128
Phone: (717) 359-7131
Reflector (Optional)
Adjustable Arm
This fixture is intended for installation in accordance with the National Electrical Code and local code
specifications. Failure to adhere to these codes and instructions may result in serious injury and/or damage
to the ballast and void the warranty. These instructions do not purport to cover all details or variations in
equipment, nor to provide for every possible contingency related to installation, operation, maintenance,
or mounting situation. Should specific problems occur that are not addressed by these instructions, contact
your Sales Representative or distributor for assistance. Retain these instructions for future reference.
SAFETY WARNING:
ALWAYS TURN FIXTURE OFF/DISCONNECT POWER AND ALLOW TO COOL BEFORE
PERFORMING ANY MAINTENANCE, INCLUDING RELAMPING AND CLEANING!
This fixture can become very HOT! The fixture housing and lens, especially if it is glass, can become hot enough
to blister hands. Attention should be paid to where the fixture is mounted, particularly if it can be touched by
children or pets. To help prevent premature failure, decreased performance, overheating and risk of fire, keep
fixture and lens clean and free of leaves, mulch, debris and mineral deposits from water. The fixture and lens
can be cleaned using a soft cloth and a solution of mild liquid soap and warm water. Wipe clean and dry with a
soft, lint-free dry cloth. Avoid polishing fixture or lens.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS!
WARNING - Lamp gets HOT quickly! To reduce the risk of FIRE OR INJURY TO PERSONS:
Do not operate fixture with a missing or damaged lens/lens assembly.
Contact only switch or plug when turning fixture on or off. Do NOT touch hot lens or housing.
Turn off or unplug fixture and allow to cool before relamping. Keep lamp away from combustibles.
Do NOT touch lamp with bare hands at any time, use a soft cloth as oil from skin may damage lamp.
32000562, revision G
INSTALLATION INSTRUCTIONS:
B4 & BU4 LARGE BULLYTES
Body
Locknut
Shroud (Optional)
Glass Lens
Shroud Screw
page 1 of 3
Advertisement
Related Manuals for Philips B4
Summary of Contents for Philips B4
- Page 1 INSTALLATION INSTRUCTIONS: B4 & BU4 LARGE BULLYTES 100 Craftway Dr. Littlestown, Pennsylvania 17340-0128 Phone: (717) 359-7131 Body Reflector (Optional) Shroud (Optional) Glass Lens Adjustable Arm Shroud Screw Locknut This fixture is intended for installation in accordance with the National Electrical Code and local code specifications.
- Page 2 Possible lamps to be used are... Aluminum/Brass Fixtures: Wattage Lamping Reflector Shroud 250W MAX PAR38 INCANDESCENT OPTIONAL 300W MAX R40 INCANDESCENT REQUIRED 150W MAX PAR38 MH REQUIRED 150W MAX E17 MH INCLUDED Composite Fixtures: Shroud Wattage Lamping Reflector 175W MAX PAR38 INCANDESCENT OPTIONAL 150W MAX...
- Page 3 NOTES: WHEN TO USE DRAIN HOLE PLUGS: (WITH PAR LAMPS ONLY!) Aiming above the horizontal: A) If fixture is mounted with the arm below the housing, the rubber drain hole plugs at the rear and bottom of the fixture should NOT be used. B) If the fixture is mounted with the arm above the base of the housing, the rubber plug in the side of the fixture must be used, but the one in the base of the fixture should NOT be used.