GE GUD27ESSM Dimensions And Installation Information

GUD27ESSM/27GSSM
GE Unitized Spacemaker
®
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
ELECTRICAL REQUIREMENTS:
GUD27ESSM Electric Dryer – This appliance should be connected to an
individual, properly-grounded branch circuit with 120/240V or 120/208V
single-phase 60 Hz electrical service and should be protected by
30-amp time-delay fuses or circuit breakers KW Rating per voltage
(240/208). This appliance is manufactured with neutral connected to
the frame. Power cord should be purchased separately.
GAS REQUIREMENTS:
GUD27GSSM Gas Dryer – This appliance should be connected to an
individual branch circuit with 120-volt single-phase 60 Hz electrical
service and should be protected by 20-amp time-day fuses or circuit
breakers. This appliance is equipped with a 4-foot long flexible U.S.
listed 20-amp power cord to match a 20-amp receptacle.
NOTE: Gas Rated input 20,000 BTU/HR. Factory equipped for natural
gas. Tested for LP gas. LP gas supply requires a conversion kit. Have a
qualified gas technician install a conversion kit before use.
Dryers must be exhausted to the outside.
INSTALLATION INFORMATION: For complete information, see
installation instructions packed with the product.
For answers to your Monogram, GE Café
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
3.8 DOE Cu. Ft. Stainless Steel Washer and 5.9 Cu. Ft. Dryer
®
™ Series, GE Profile
® Service, 800.626.2000.

Installation Instructions

27" NOMINAL PRODUCT DIMENSIONS
18-5/8"
12-1/2"
Vent
75-7/8"
53-1/4"
36-7/8"
Drain outlet
3-7/8"
22-1/4"
26-3/4"
* Dimension represents door closed including handle and knobs.
NOTE: With feet set at mid position, feet can be adjusted +/- 3/8".
™ Series or
*26-1/8"
47 1/2"
Water Inlets
51°
3"
4-3/8" 34-3/8"
30-7/8"
Specification Revised 11/17
Gas Inlet
3"
Listed by
Underwriters
Laboratories