Warning
The use of a call device does not release supervisors from the obligation to supervise the persons
supported by such a device. This system is radio-based and must therefore not be used for monitoring
purposes if life-threatening conditions are foreseeable.
Package contents HC-140
Product variants
AAL Profiline hand transmitter with wristband
AAL Profiline hand transmitter with necklace
AAL Profiline multi-propose transmitter with wristband and necklace
Bedienungsanleigung
1
Order number and
While unpacking, each shipment should be inspected for completeness and damage.
Note: In this instruction manual, the "AAL Profiline hand transmitter and multi-purpose" is referred to as "hand
transmitter".
Fig.1: Hand transmitter
Putting into operation
The hand transmitter is supplied ready for operation with battery. Initial putting into operation only requires
programming to the desired AAL Profiline receiver and checking the radio range in the operating environment.
Triggering a call
A radio call is triggered by pressing the red actuating area. This is indicated by illumination of the red call LED below
the cover. The LED messages are listed in the enclosure, table 1.
Programming / deleting the hand held transmitter to / from a radio receiver
The "programming" to the radio receiver required for initial putting into operation and the "deletion" from the radio
receiver that may be required if the transmitter is ported to another radio receiver can be found in the instruction
manual of the respective radio receiver.
Range of the radio link
The range meets the requirements of the technical inspection body of the German health insurance funds. Within
buildings, a range of approx. 30 m can be expected. However, the range depends to a large extent on the local
conditions.
Checking the range at the usage site
Before using the transmitter for the first time, an interference-free operation of the radio link has to be ensured.
Proceed as follows:
1.
Switch on all electronic entertainment and communication devices (e.g., television sets, game consoles, and
computers) in the immediate environment.
2.
Check if the radio message is received by the radio receiver at a distance exceeding the intended usage
distance by approx. 5 to 10 m. Ensure that the message is trigged by a single call triggering!
Important: Repeat the check if the positions of electronic devices are changed or new electronic devices are put into
operation in the immediate environment of the usage site.
AAL
Homecare
INSTRUCTION MANUAL
AAL Profiline Transmitter
2
frequency can be found on the identification decal.
Actuating area
HC-140-BA-EN V1.02 Transmitter page 1 of 4
HC-125-BA V0.01 Armbandsender
Fon +49 (0) 2208 9339170
Bestellnummer
HC-125
HC-135
HC-145
HC-140-BA-EN
Seite 1 von 4
Fax +49 (0) 2208 9339063
1
1
Frequenz
869,23 MHz
869,23 MHz
869,23 MHz
Call LED (red)
www.aal-homecare.com