Table of Contents
Advertisement
Quick Links
T A N S U N
Q U A R T Z H E A T
Reference Manual
Rio
MODELS 1.0kW / 1.5kW / 2.0kW
Horizontally Mounted
MODELS 1.0kW / 1.5kW
Vertically Mounted
Spectrum House, Unit 1, Ridgacre Road, West Bromwich,
West Midlands, B71 1BW, England
Tel: +44 (0)121 580 6200 . Fax: +44 (0)121 580 6222
Email: quartzinfo@tansun.com . Website: www.tansun.com
Advertisement
Table of Contents
Related Manuals for Tansun Quartzheat Rio 010
Summary of Contents for Tansun Quartzheat Rio 010
- Page 1 T A N S U N Q U A R T Z H E A T Reference Manual MODELS 1.0kW / 1.5kW / 2.0kW Horizontally Mounted MODELS 1.0kW / 1.5kW Vertically Mounted Spectrum House, Unit 1, Ridgacre Road, West Bromwich, West Midlands, B71 1BW, England Tel: +44 (0)121 580 6200 .
-
Page 2: Risk Of Fire
Power from from from side W x H x D (lb) (kW) floor (ft) ceiling (ft) wall (in) (in) *Rio 010 USA* 7' 10 x 4 x 4 3lb 10oz *Rio 015 USA* 12.5 7' 10 x 4 x 4... -
Page 3: Installation Instructions
Installation Instructions The Rio heater is fitted with a supply cable and a moulded plug, therefore the terminals should not be interfered with. The following points should be considered when positioning the heater: Please observe the minimum safe distance between the heater body and any inflammable surfaces. - Page 4 Replacing the Lamp - Terminal Box Models 1. Ensure the heater and lamp are cool and the power supply is disconnected by removing the plug from the socket outlet. 2. Remove the heater from its mounting and work on a safe, flat surface. 3.
- Page 5 Fig. 9 Fig. 10 11. Take your new lamp and refit by ensuring the leads pass down the sides of the lamp holders. The lamp can be clipped in by pulling the tabs back (Fig. 11). Fig. 11 12. The guard and side reflectors can now be refitted. Starting with the guard, slide it down its track and roughly centralise it.
- Page 6 16. At this point, the new lamp can be connected. Firstly remove the connector block saddle by removing the screw and lifting out. The connector block can be lifted out of its locating lugs to allow for better access when connecting the new lamp (see Fig.
-
Page 7: Following Information Is Only For Eu-Member States
23. The heater can now be returned to its original mounting position and the mains power reconnected. Fig. 23 Replacing the Lamp - Direct Wired Models 1. Ensure the heater and lamp are cool and the power supply is disconnected by removing the plug from the socket outlet. - Page 8 Spectrum House, Unit 1, Ridgacre Road, West Bromwich, West Midlands, B71 1BW, England Tel: +44 (0)121 580 6200 . Fax: +44 (0)121 580 6222 Email: quartzinfo@tansun.com . Website: www.tansun.com © Tansun Limited 2004. Part No. 042216. Issue 2 September 2006.