Advertisement
Quick Links
Installation Instructions for
Epson R1900 Easy Flow IV
CONTENTS
1. Easy Flow IV Ink Reservoirs & Cartridges
2. Installation Manual and Instruction CD
3. Tube Support Bracket
4. Lid Support Bracket
5. Screwdriver
6. 10ml Syringe
7. Long Needle
8. Sharp Needle
9. Spare elbows and bungs
10. Air Filters
11. Spare Sticky Pads
Page | 1
Advertisement
Related Manuals for Epson EASY FLOW IV R1900
Summary of Contents for Epson EASY FLOW IV R1900
- Page 1 Installation Instructions for Epson R1900 Easy Flow IV CONTENTS 1. Easy Flow IV Ink Reservoirs & Cartridges 2. Installation Manual and Instruction CD 3. Tube Support Bracket 4. Lid Support Bracket 5. Screwdriver 6. 10ml Syringe 7. Long Needle 8. Sharp Needle 9.
- Page 2 Turn on the printer and press the ink button. When the printhead has moved to the cartridge removal position unplug the mains cable from the printer. This allows the printhead to be manually moved. Remove the printhead lid. Use the small screwdriver provided to prise the hinges open Remove any cartridges from the...
- Page 3 Repeat this for each color then fit the supplied air filters. Place the bottles to the left of the printer as shown. NEVER PLACE THE BOTTLES HIGHER THAN THIS Move the printhead as far to the left of the carriage as possible. Feed the cartridges under the printer housing…...
- Page 4 Place the cartridges into the cartridge housing and press them down firmly by spreading fingers across all the cartridges. Important: ENSURE THAT EACH CARTRIDGE HAS CLICKED INTO PLACE. Remove the backing tape from the sticky pads on the tube support bracket. Position the bracket around the printer button housing, ensuring that the plastic tab fits into the slot.
- Page 5 If you wish to close the printer lid you will need to attach the lid support brackets as shown. Plug in the mains power cable and turn on your printer. The printer will go through the initial head charge before your system is ready for use.
- Page 6 Press the ink button and the printhead will read the chips and begin the initial head charge. Your system is now ready for use. Print a nozzle check to ensure all heads are printing ok. Read the following section if you do not have a perfect nozzle check.
- Page 7 See the Installation CD that came with your system for: Profile Installation Epson Driver Configuration Graphic Software Configuration After the ink charge, print out a nozzle check to see if all the colors are printing correctly. If they are, you are set to go. If not, perform a head clean and test the nozzle check again.
- Page 8 REFILLING THE BOTTLES Remove the air filters and replace the small rubber bungs (that you did not throw away). Remove the large rubber bungs This sequence prevents the chambers filling with ink. Refill the bottle through the large opening. REPLACE THE LARGE RUBBER BUNG FIRST! Then remove the small bung and replace the air filter.