GTUP240EM/240GM
GE
24" Unitized Spacemaker
®
Dimensions and Installation Information (in inches)
Electrical Requirements:
GTUP240EM Electric Dryer – This appliance should be connected to an
individual, properly-grounded branch circuit with 120/240V single-phase
60 Hz electrical service and should be protected by 30-amp time-delay
fuses or circuit breakers. This appliance is manufactured with neutral
connected to the frame. Power cord should be purchased separately.
Note:
These appliances are not approved for 120-volt operation.
Gas Requirements:
GTUP240GM Gas Dryer – This appliance should be connected to an
individual branch circuit with a three-prong grounding-type receptacle
and 120-volt single-phase 60 Hz electrical service and should be
protected by 15- or 20-amp time-delay fuses or circuit breakers. This
appliance is equipped with a 6-foot long flexible U.L. listed 20-amp power
cord to match a 15-amp receptacle.
Gas Rated input 10,500 BTU/HR. Factory equipped for natural gas. Tested
for LP gas.
Dryers must be exhausted to the outside.
Installation Information:
For complete information, see installation instructions packed with
the product.
For answers to your Monogram,
GE Profile
®
GE
®
appliance questions, visit our website at
geappliances.com or call GE Answer Center
service, 800.626.2000.
27-1/4
Washer and Dryer
®
27-1/2
74-1/2
or
™
32-7/10
®
23-3/4
21-5/16
27-1/2
Distance
from vent
to back 4-1/2"
32-7/10
19-
11/100
Drain
27-1/4
23-3/4
1" For leveling legs
8
27-1/4
74-1/2
1/2
37
26-3/5
Water
inlet-
cold
Floor line
Specification Revised 2/11
27-1/2
Distanc
from ve
to back
74-1/2
32-7/10
23-3/4
Listed by
Underwriters
Laboratories
360329