Siemens IP Controller N350E Technical Product Information

IP Controller N350E
Product and Applications Description
The IP Controller N350E is a DIN rail mounted device.
It provides these functions:
· Weekly scheduler
with up to 100 schedule entries for up to 80 channels,
with up to 8 periods for weekly schedules,
with astronomical schedule function
(+/- 2 hours from sun rise / sun set
· Annual schedule
with up to 50 schedule entries for up to 80 channels
· 30 Logic gates
· Event programs with a total of up to 200 event com-
mand actions
· Event program trigger via schedules, logic functions or
up to 30 threshold values
· Configuration of scheduler functions, event programs,
and logic functions via IP network
(protocol used: KNXnet/IP Device Configuration)
· Battery buffered real-time clock
· Display of date and time on LC-display
· Real-time clock setting manually with three push but-
tons or automatically by a network (Internet) time ser-
vice
· Time zone selection for automatic time synchroniza-
tion
· Automatic Daylight Savings Time change-over se-
lectable
· DHCP for automatic IP address assignment
· Communication via IP network with
- a visualization software
- ETS3 acting as a configuration interface
Siemens AG
Infrastructure & Cities Sector, Building Technologies
Control Products and Systems
P.O. Box 10 09 53, D-93009 Regensburg
Via ETS up to 80 objects can be defined for the device
with free data type assignment from this list of data
types
· 1 bit (EIS1)
· 1 Byte, unsigned (EIS 14)
· 1 Byte, signed (EIS 14)
· 2 Byte, unsigned (EIS 10)
· 2 Byte, signed (EIS 10)
· 2 Byte, float (EIS 5)
· 4 Byte, unsigned (EIS 11)
· 4 Byte, signed (EIS 11)
· 4 Byte, float (EIS 9)
All defined objects can be used freely by all software
modules. Hence, up to 80 objects can be selected from
for schedule functions, as input for logic gates, as event
triggers, or as output of event programs (scenes).
With the ETS (Engineering Tool Software) the application
program is selected, its parameters and addresses are
assigned appropriately, and downloaded to the IP Con-
troller N350E.
Application program
21 CO IP Controller 908701
· 80 objects
· 100 schedules
· 50 annual schedules
· 100 event programs (scenes)
· 10 logic gates
· sends date and time
· IP communication for remote configuration and visual-
ization
Supported Software
Here is a list of software supporting the IP Controller
N 350E.
ComBridge Studio Evolution
ETS
N350E, 4 Seiten
© Siemens AG 2013
Subject to change without further notice
Technical Product Information
IPAS GmbH
Hölscher Str. 27
47167 Duisburg
[ http://www.ipas-products.com
KNX Association
De Kleetlaan 5, Bus 11
B-1831 Brussels-Diegem
[ http://www.knx.org ]
Update: http://www.siemens.com/gamma
GAMMA instabus
February 2013
5WG1 350-1EB01
]
Technical manual
2.12.1.12/1