Installation Instructions Full Size Tumble Action Washers Before beginning installation, carefully read these instructions. This will simplify installation and ensure the washer is installed correctly and safely• Leave these instructions near the washer after installation for future reference. NOTE." The electrical service to the washer must conform...
PRE-INSTALLATION REQUIREMENTS in accordance with all localcodes and ordinances or in the absence of localcodes, with the National Tools Required for Installation: Electrical Codes, ANSI/NFPA 70 (latest edition). 1. 1/4 in. nut driver If in doubt, call a licensed electrician. DONOT 3/8 in.
ROUGH-IN DIMENSIONS 263A (67.9) ,=__ 60 24 s/,_j" (152.4)_" 1 11/= (91.5) I I I_ Power Under Counter IWi_I_ Cord 345/8 I I jp_j_ (85) (87.9) inch (ore) A_ustable Legs RollerWheels UNDER COUNTER INSTALLATION If an under counter* installationis desired, the washer MUST have a top sheet kit installed, PIN 131445600. Kit is available from an authorized parts distributor.
LOCATION OF YOUR WASHER DO NOT INSTALL YOUR WASHER: In an area exposed to dripping water or outside Remove the styrofoam base. weather conditions. The ambient temperature Carefully return the washer to an upright position and remove the carton. should never be below 60 degrees F (15.6 degrees C) for properwasher operation.
INSTALLATION Run some water from the hot and cold faucets to flush the water lines remove particles that might clog up the water valve screens. Remove the inlet hoses and rubber washers from plastic bag and install rubber washers in each end or standpipe and secure with the cable tie provided in of the inlet hoses.