Page 1
NOTE; PERSONAL AND CUSTOM PREFRERENCES WILL BE LOST UPON COMPLETION OF THIS FIRMWARE UPDATE. PLAEAE MAKE NOTE OF ANY PREFERENCE SETTINGS PRIOR TO STARTING THIS FIRMWRE UPDATE. How to upgrade the Software Connect the AC power and turn “ON” the TV receiver. The USB reader is located on the left of the cabinet near the side control/jack assembly as shown in Figure1.
Page 2
Insert the “USB Drive” into the USB slot as shown in Figure2. Figure2 After insertion of USB Drive into reader slot a Media Browser information window will appear as shown in Figure3. Figure3 If the window is no present, remove the USB Drive and try reinserting the USB Drive again. Press “Menu”...
Page 3
The software upgrading menu will appear as shown Figure4. Do you want to update software ? Figure4 Press “OK” button of the remote controller to begin the upgrade. The software upgrading process will begin. During the software upgrade, the TV receiver will display “Software upgrade”...
Page 4
Press “MENU” button on the remote controller and select “Install and Retune” by using “Left” or “Right” button to perform the “First time installation” function. Press “OK” button and the following menu screen will be displayed as showing figure6. Figure6 Select “First time installation”...